Update your settings

Registering MDS D139 with RF290R and Moby ASM 475

Based on the information and image provided, you're attempting to register an MDS D139 using a Siemens RF290R and Moby ASM 475 module. Forcing DB47.0 to '1' is typically the initial step, but further actions are needed for successful registration.

Here's a breakdown of the typical procedure and troubleshooting steps:

1. Initialization: Ensure the RF290R is in the correct mode for MDS device registration. Refer to the RF290R manual for details on initiating registration mode.
2. Command Sequence: Simply setting DB47.0 to 1 is likely not sufficient. A complete command sequence might be necessary, involving setting other bits in DB47 or using subsequent DBs for data transfer (D139 ID, etc.).
3. Moby ASM 475 Configuration: Verify the Moby ASM 475 module is properly configured to communicate with the RF290R and supports MDS D139 registration.
4. Error Checking: Check the RF290R's diagnostic outputs (DBs related to status and error reporting) to see if any errors are indicated during the registration attempt.

Resources:

• RF290R Documentation
• Moby ASM 475 Documentation
• SiePortal Knowledge Base: Search for "RF290R MDS D139 registration" for specific application notes or FAQs. SiePortal

For detailed guidance, please consult the RF290R and Moby ASM 475 manuals or search the SiePortal knowledge base using the keywords mentioned above. If you still encounter issues, please provide the specific configuration of your system, and any error messages received.