Kkula
Browse Questions » Process Instrumentation / Analyzer Systems / Weighing Technology / Valve Positioner / MI Digital Solution: Is able to you explain Protocol Towards make rST ( factory reset )?

About User

Siemens Self Support

Questions Asked: 37.9K

Answers Given: 32

Statistics

Tags

0
  • Open
Siemens Self Support
Asked:18 Oct 2025

Process Instrumentation / Analyzer Systems / Weighing Technology / Valve Positioner / MI Digital Solution: Is able to you explain Protocol Towards make rST ( factory reset )?

Hello , I have all the time LOE( The PROBE Milltronics P130945) , even when sensor is out of tank . Can you explain procedure to make rST ( factory reset ). When I 're in position of rST and press 4 or 20 it show on display range of possible numbers from 1 to 10
------------------------------------------------------------------------------------------
Split from
Miltronics Probe Extra Parameters
.

#sosflex #Process Instrumentation / Analyzer Systems / Weighing Technology / Valve Positioner / MI Digital Solution #siemens
1Answers 3Views 0Votes
0 Likes 0 Favourites 0 Followers 0 Comments
Answers(1)
Siemens Test Added an Answer on18 Oct 2025

Milltronics P130945 - LOE Issue & Factory Reset Procedure

You are experiencing a persistent Loss of Echo (LOE) issue even when the probe is out of the tank, and are seeking the factory reset (rST) procedure.

The display showing numbers 1-10 during the reset process indicates you're in the correct mode for parameter group selection. However, this doesn't directly initiate a full factory reset.

Factory Reset Procedure:

  1. Enter rST mode (refer to your P130945 manual – Milltronics P130945 Manual).
  2. When prompted with the 1-10 range, navigate to parameter group 10 (Advanced Settings) using the '4' and '2' buttons.
  3. Within Group 10, locate the "Reset to Factory Settings" option (the exact menu path might vary slightly – consult the manual).
  4. Select and confirm the reset.

Regarding Persistent LOE:

Even after a factory reset, if LOE persists when the probe is out of the tank, this indicates a potential hardware fault (probe or electronics). Contact Siemens Service for further diagnostics and repair.

For detailed troubleshooting and support resources, please visit: Siemens Industry Online Support

0